By default, all runtime API calls to Apigee Edge for Private Cloud use IPv4. You can add IPv6 support to the Router by
setting the
`conf_load_balancing_load.balancing.driver.nginx.listen.endpoint.all.interfaces.enabled`
property to `true` on your Router.

> [!IMPORTANT]
> **TIP:** You can check if IPv6 is already enabled by logging into the Router and searching for this property, as the following example shows:
>
> ```
> /opt/apigee/apigee‑service/bin/apigee‑service edge‑router configure 
>   ‑‑search 
>   conf_load_balancing_load.balancing.driver.nginx.listen.endpoint.all.interfaces.enabled
> ```

**To enable IPv6 on your Router:**

1. Log in to the Router.
2. Open the `router.properties` configuration file in an editor:

   ```
   vi /opt/apigee/customer/application/router.properties
   ```

   If the file does not exist, create it.
3. Set the following property to `true`:

   ```
   conf_load_balancing_load.balancing.driver.nginx.listen.endpoint.all.interfaces.enabled
   ```

   For example:

   ```
   conf_load_balancing_load.balancing.driver.nginx.listen.endpoint.all.interfaces.enabled=true
   ```
4. Save your changes to the properties file.
5. Restart the router by executing the following command:

   ```
   /opt/apigee/apigee‑service/bin/apigee‑service edge‑router restart
   ```

   During the restart, you should see output that is similar to the following:

   ```
   [ChangeDelta, position: 775, lines:
     [load.balancing.driver.nginx.listen.endpoint.all.interfaces.enabled=false] to
     [load.balancing.driver.nginx.listen.endpoint.all.interfaces.enabled=true]]
   ```
6. Configure your router's IP address and ports so that incoming API requests resolve to the IPv6 address/ports. Note that incoming API requests must be sent from IPv6 enabled clients.
7. Test your configuration by making an API request to your Router's IPv6 address and port.